[NSRCA-discussion] Need pipe mounting suggestion(s)

[Ron Van Putte]

I had exactly this problem.  I took a 6" length of insulated braided  
copper wire.  I bared the ends of the wire and soldered them  
together.  I pushed the wire "circle" together and slipped two short  
pieces of heat shrink tubing over the wire, with enough space between  
them to allow a button head bolt to go through.  Then I shrunk the  
heat shrink tubing.  I mounted a blind nut inside the fuselage and  
screwed the bolt into the blind nut.  Now I had two loops sticking  
out on either side of the pipe and ran a length of zip tie through  
one loop, over the pipe,  through the other loop and back to make the  
connection.

Ron VP

On Jul 4, 2009, at 8:24 PM, Ihncheol Park wrote:

> I am in the middle of work with YS engine and current rigid header  
> & short aluminum pipe from Hatori.
>
> Engine is on Hyde mount.  Type A.
>
> There is only about 1/8" space between the floor to the bare pipe,  
> so no mounting hardware.
>
> How should I proceed on mounting the pipe?
>
> Any suggestion(s)?
>
> Thank you,
>
> Ihncheol
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion