[NSRCA-discussion] Random tip on ATV and setup

[tocdon at netscape.net]

Sub trim is a function that moves the servo to get the control?surface centered. This in conjunction with end point adjustments can have an adverse effect on servo speeds. You are basically stretching the number of steps for the same amount of travel, among the servos. I was at the FARM club helping out a giant scale newbe last fall and he was flying a third scale H9 Extra 330 with Futaba 8 channel and Hitec servos. One of his servos literally trailed the other one by about 20 or so degrees when moving the elevators up and down in a rapid fashion. He said a servo was bad. Actually, backing up a bit- when he was flying he asked my help to trim his plane and handed me the transmitter. When I tried some waterfalls, it peeled off really bad. When I landed, that is when I saw the elevators moving at different speeds. Upon inspection I found he used the electronic sub trim to get the servos aligned and massive atv end point to get the ends the same throw. He also had the ATVs set a
 t nealy 150 percent. I think he was like, off one complete servo arm tooth and used the sub trim to get the servo back to center. After about 2 hours getting everything mechanically adjusted, the plane flew so much better. It went from something nearly crashing to a competitive IMAC and 3D setup. Any case, I had an identical experience when helping a flyer in Vanceboro, NC last year (after the pattern contest completed). Exact same issue on his (scale) plane. He thought the Rx was bad until I showed him what the deal was. After mechanically adjusting to get it close, all was well. 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20090220/e0245e2e/attachment.html>