[NSRCA-discussion] Header Coupling

[Ron Van Putte]

I stand corrected.  They must have changed their length policy; I  
haven't ordered any in a year or so.  BTW, make sure that you get the  
thick-wall PTFE tubing.  In some IDs there might be two listings.   
The thin-wall tubing "folds, rather than "curves", when trying to  
bend it in a radius.

Ron VP

On Feb 5, 2009, at 11:58 AM, Duane Beck wrote:

> http://www.mcmaster.com/nav/enter.asp?partnum=8547K15
>
>
> The above part number 8547K15 is sold cut-to-length, by the foot.
>
>
> Duane
>
>
> ----- Original Message -----
> From: "Ron Van Putte" <vanputte at cox.net>
> To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
> Sent: Thursday, February 5, 2009 12:47:55 PM GMT -05:00 US/Canada  
> Eastern
> Subject: Re: [NSRCA-discussion] Header Coupling
>
> I use Teflon purchased from McMaster-Carr.  They have PTFE (high
> temp) tubing in various IDs, including 3/4".  You have to purchase it
> in at least 5 foot lengths.  I cut it in one foot lengths and sell
> what I won't need for a while.
>
> Ron VP
>
> On Feb 5, 2009, at 11:23 AM, Jay Marshall wrote:
>
> > I need some vinyl(?) tubing from an OS140 header to a Bolly pipe.
> > The ID should be ¾”. Any suggestions for a source/part no.?
> >
> >
> > Jay Marshall
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion