[NSRCA-discussion] Futaba Servos

[Ed Alt]

You could do that too, using something like 26AWG for the signal leads.  The servos we use in the tail don't draw all that much, so 22AWG shared on the power should do fine.  Test it though.

Ed
  ----- Original Message ----- 
  From: Bob Richards 
  To: General pattern discussion 
  Sent: Friday, December 11, 2009 12:43 PM
  Subject: Re: [NSRCA-discussion] Futaba Servos


        I've often thought about going with common + and - wires with an upgraded wire size. Then go tiny with the signal wires. There is no reason to go with a large gauge on the signal wires.

        Bob R.

        --- On Fri, 12/11/09, Ed Alt <ed_alt at hotmail.com> wrote:

          Sorry, I meant to say common power leads (+ and - ) for both servos.  The only unique lead is the signal lead.  Test it well before flying.

          Ed
       



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20091211/2d6f066d/attachment.html>