[NSRCA-discussion] JR question

[AWorrest at aol.com]

For the 9303, to make the trainer button a momentary kill switch, first go 
to the DeviceSEL menu and set AUX4 to be activated by BUTN. Leave AUX4 
output active.

In a linear program mix menu, mix AUX4 into THRO. In Pos1 lower position, 
set the value to +100%. Set the THRO STK to some low value like 12 so the 
kill will only take place when the throttle stick is in the idle position.

The only problems that some people may have is with the timer. If you use 
the trainer button to start the timer, you will momentarily cause the engine 
to go low. Most engines will not stop with a quick blip on the button that 
is needed to start the timer. But if this is a problem, use the timer switch 
on the front panel. The other thing is that killing the engine will stop the 
timer. I find this to be a benefit.

Allan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20090825/b2defaad/attachment.html>