[NSRCA-discussion] Futaba R6014FS Receivers

[Rusty Fried]

I am flying a 35%  extra with 4 8711 jr's and 4 9156 futabas  and have had
no problems in some very high temps about 108degrees. (Rusty Fried) 

 

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of James Oddino
Sent: Thursday, November 20, 2008 10:20 PM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Futaba R6014FS Receivers

 

The JR servos I tested worked down to about 1.2 volts but the buffer amps
required about 2.7 volts so they are a on the ragged edge.

 

Jim 

 

 

On Nov 20, 2008, at 7:15 PM, MKMSG wrote:





I was reading the FAQ section of the Futaba website when a particular item
caught my eye regarding the R6014FS 2.4 receiver.  The FAQ states that the
use of non Futaba digital servos with the R6014FS receiver may be
problematic due to the 6014's lower output voltage of 2.7 volts.  Since I do
occasionally mix and match Futaba and JR servos and use the 8 channel 2.4
receiver, I wondered if this issue was common to all Futaba 2.4 receivers.
Here's Futaba's answer: "The FAQ refers only to the R6014FS receiver, this
is the only one that has the lower voltage."  Just thought I'd pass this
along in case someone experiences performance anomalies with the 6014
receivers using other than Futaba servos.

 

Mike

NSRCA 35

 

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20081121/60e7deb0/attachment.html>