[NSRCA-discussion] Desperate-Final Update...I hope...

[Ken Thompson]

Glad you found the issue John, at least it appears so.  The best of luck this weekend...mind on the contest, not the motor :-)
  ----- Original Message ----- 
  From: John Konneker 
  To: Discussion List 
  Sent: Thursday, May 29, 2008 4:33 PM
  Subject: Re: [NSRCA-discussion] Desperate-Final Update...I hope...


  First I wish to apoligize to the list if it seemed I was a little frustrated last night.  I was and I let it show.  I am sorry.
  Now for the good news...I think.  
  Just got finished running the motor on the stand.  Earlier today it appeared the head gasket was leaking.  But I need to back up a little first.  
  I had a new, unused 1.60 in the box.  Last night I decided I would put it on the Focus this morning and run it.  I still wasn't convinced I would make the Menomonee Falls contest this weekend since I was afraid I would not have the motor broken in well enough for a reliable idle.
  All I need is to get caught at the bottom of a stall turn way out and down wind with a dead motor.  When I tried to run the new motor a pretty severe mechanical issue raised it's head.  Richard graciously agreed to warranty the motor but trying to run it was absolutley out of the question.
  So...there I was with two motors going back.  He convinced me that I should be able to find the leak...like so many of you tried to.  He agreed that I could take what I needed off the new motor.  Long story short I replaced the head gasket and after running it for about half a tank on the stand it seems dry.  I'm about to go out and finish the tank but it looks good so far.  
  Thanks to all of you for the  advice and suggestions.  I tried to run down each and every one.  In the process I learned a lot!
  That's what it's all about.
  A very big thank you!!!
  See you in Wisconsin tomorrow!
  :-)
  JLK




----------------------------------------------------------------------------
    From: jlkonn at hotmail.com
    To: nsrca-discussion at lists.nsrca.org
    Date: Wed, 28 May 2008 19:03:52 -0500
    Subject: [NSRCA-discussion] Desperate

    I have a bad fuel/exhaust leak on my YS 1.60.  It started just before my NMP header split but continued after replacing with 
    a Hatori header and 821 muffler.  I'm getting pretty desperate trying to find it.  I have replaced all the fuel lines.  I have snugged up 
    the flange that screws in to the head.  I have retightened the header flange.  I have checked the valve cover gasket.  I have checked 
    the head bolts but it still leaks.  I consider the leak bad enough that if I don't get it fixed by tomorrow I will have to miss my second contest in a row because of it.  It really soaks the inside of the engine compartment on the left (exhause) side.  Bad enough that when I run my finger down the firewall it is wet with oil.  The engine mount beams on the bottom sides are almost dripping.  
    Any thoughts?
    Thanks!
    JLK
     



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080529/b4cf1c5e/attachment.html