[NSRCA-discussion] 9303 dual elevator setup....

[Royce Dorsett]

I am using duel servos. I have the (right) elevator plugged in to the elevator (receiver) and the (left) plugged into aux 2. I had it on (mix 3), but when I moved the stick, the elevators moved at different rates and not the same travel. I figured that I had it on the wrong mix. I tried to set the tell to ' V tail '. The elevators seemed to work fine, but of course the rudder was moving along with them.......
  ----- Original Message ----- 
  From: Jay Marshall 
  To: 'General pattern discussion' 
  Sent: Sunday, May 25, 2008 5:42 PM
  Subject: Re: [NSRCA-discussion] 9303 dual elevator setup....


  I assume you are using dual servos? Try a Futaba SR-10 Dual Servo Reverser (Tower)



  Jay Marshall 

  -----Original Message-----
  From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Royce Dorsett
  Sent: Sunday, May 25, 2008 5:30 PM
  To: General pattern discussion
  Subject: [NSRCA-discussion] 9303 dual elevator setup....







  Trying to figure out how to set up a duel elevator setup with a 9303.... Can anyone please help?



  Thanks,



  Royce 



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080525/1b0c5002/attachment.html