[NSRCA-discussion] Rudder servo wheel part 2

[Verne Koester]

Chris,
Never had a problem with derailed cables on wheels and always ran them straight. I was always worried about electrical noise if the nylon wore off the cables where they crossed.

Verne
  ----- Original Message ----- 
  From: chris moon 
  To: nsrca-discussion at lists.nsrca.org 
  Sent: Tuesday, May 20, 2008 6:44 PM
  Subject: [NSRCA-discussion] Rudder servo wheel part 2


  I have the rudder servo setup now with the Hangar 9 servo wheel. The 
  cables from the servo to the rudder are not crossed and run straight 
  back. My question is that it would seem that crossing the cables would 
  actually be a good idea when using a wheel since that would increase the 
  angle that the cable meets the wheel and make it less likely for the 
  cable to get derailed. Does anyone who is using a wheel have any 
  input? Should I just leave them straight or cross them? By the way, 
  the cables are not inside any tubes and would be rubbing together if I 
  crossed them.

  Thanks

  Chris



------------------------------------------------------------------------------
  Make every e-mail and IM count. Join the i’m Initiative from Microsoft. 


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080520/241a8b40/attachment.html