[NSRCA-discussion] YS help

[Keith Hoard]

Have you tried freezing it?  You may get lucky and the crank will shrink
more than the bearing?

On Fri, Jul 4, 2008 at 4:39 PM, Bob Kane <getterflash at yahoo.com> wrote:

> Well, for all the YS engines I have rebuilt, I'm stuck with a situation I
> have not run into before. I dissassembled 160DZ to replace the main bearing.
> The 2nd to the last step in the dissassembly porcess is to remove the crank.
> A few light taps and it normally slides out. Well, this time the bearing
> stayed on the crank. Usually it stays in the crankcase. Normally I would
> heat the cranckcase to get the bearing to fall out, but how do you get a
> stuck bearing off the crank? The fully circular rear face of the crank shaft
> makes getting to the bearing difficult.  Suggestions?
>
> Bob Kane
> getterflash at yahoo.com
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>



-- 

Keith Hoard
Collierville, TN
khoard at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080704/3e32f0b6/attachment.html>