[NSRCA-discussion] Question about Hyde ARIA Mount for YS110

[JShulman]

Of course 2/3rd's the way down on this page it also has instructions...

http://www.centralhobbies.com/Engines/mounts/hydmnts.html

Regards,
Jason
www.jasonshulman.com
www.shulmanaviation.com
www.composite-arf.com

  -----Original Message-----
  From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Claude Weimer
  Sent: Monday, September 17, 2007 11:00 PM
  To: 'NSRCA Mailing List'
  Subject: Re: [NSRCA-discussion] Question about Hyde ARIA Mount for YS110


  If you have a Hyde mount and don’t know the part number then you probably
didn’t buy it from Central Hobbies. Instead of blaming Central you need to
call Merle. If no one on the list has his number I can dig it up, I have it
somewhere. It has been my experience that Central and Merle Hyde have always
been helpful.



  Claude




----------------------------------------------------------------------------
--

  From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of DwayneNancy
  Sent: Monday, September 17, 2007 9:34 PM
  To: 'NSRCA Mailing List'
  Subject: Re: [NSRCA-discussion] Question about Hyde ARIA Mount for YS110



  I’ve got a Hyde mount too w/o any instructions.  I’ve been in contact with
Central Hobbies but all I get there is a the run around.  I guess they think
anyone should be smart enough to figure the mounting procedure.  Let me know
if you get any instructions.  Mine is for a YS 1.20.  It has a nose ring too
but I don’t know the mount designation or p/n.  Dwayne



  -----Original Message-----
  From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Richard Lewis
  Sent: Monday, September 17, 2007 9:12 PM
  To: 'NSRCA Mailing List'
  Subject: [NSRCA-discussion] Question about Hyde ARIA Mount for YS110



  I have a Hyde ARIA mount that I got with no instructions.  There are is a
normal 4 hole pattern in the backplate, two centered holes that pass through
the aluminum nose ring support, and a single hole in the center that appears
to be tapped for 1/4x20.  What is standard mounting procedure for this
mount?



  Richard

No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.487 / Virus Database: 269.13.22/1013 - Release Date: 9/17/2007
1:29 PM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070918/515149b6/attachment.html