[NSRCA-discussion] YS 140 Sport help

[Pete Cosky]

here is an exploded diagram of the engine for you

http://www.julton.net/FZ140s.pdf
  ----- Original Message ----- 
  From: DoWayne Gould 
  To: 'NSRCA Mailing List' 
  Sent: Friday, September 14, 2007 9:06
  Subject: Re: [NSRCA-discussion] YS 140 Sport help


  Thanks for the tips so far;

  Well it's plumbed correctly, same as the picture, regulator housing is installed correctly and check valve is good.

  Is there anything in the cam housing or back plate area that could be installed wrong?

  Dowayne

   


------------------------------------------------------------------------------

  From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of William C. Harden
  Sent: Friday, September 14, 2007 6:47 PM
  To: 'NSRCA Mailing List'
  Subject: Re: [NSRCA-discussion] YS 140 Sport help

   

  This is what the regulator and fuel line hookup from regulator to carb should be.  

   

   


------------------------------------------------------------------------------

  From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of DoWayne Gould
  Sent: Friday, September 14, 2007 1:52 PM
  To: 'NSRCA Mailing List'
  Subject: [NSRCA-discussion] YS 140 Sport help

   

  I have a 140 Sport that I can't get running right. I bought it used from a fellow that only used it to tow gliders on Thursday afternoons and always ran like a top for him.....(yeh right).

  Any way I can get it started barely and it will idle real low if you try to advance the throttle it acts like it leans and dies. The diaphragm, plunger and seat looked good but I replaced them anyway. While checking the plumbing I noticed that if I removed the short blue fuel line from the pump to the carb and hand propped it in the direction of rotation I would get just a little fuel spurting out. If I spin it with my starter no fuel would come out. If I spin the prop in reverse fuel sprays out in a full stream. It seems to me it's not going to run till I can get fuel to pump in correct direction unless I can find a 2 meter pusher.

   

  Any ideas on what is installed backwards? If it matters Powermaster 20/20, OS F, APC 16-10

  Thanks

  Dowayne



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070915/84217321/attachment.html