[NSRCA-discussion] OS 120 Ax bearing replacement

[John Pavlick]

Has anyone replaced the bearings in their OS 120 Ax? What's the trick? I've done plenty of bearings but this one is different. After removing everything, including the sleeve, I can't slide the rod far enough back to get it off the crankpin. The pin boss in the piston is too narrow to allow the rod to slide far enough. If anyone has done this already I'd appreciate any insight. Thanks!

John Pavlick
http://www.idseng.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070531/b89d00c7/attachment.html