[NSRCA-discussion] YS-160 setting

[Mark Atwood]

Hey Jason,

I'm sure Troy will jump in here as he's got WAY more experience with this
motor, but I'm betting you're simply still too rich.  Unlike the YS's of
yore (before you began studying Ohm's law) lean was a YS taboo.  Now it's
almost the opposite.  I'm almost to the point where I set my needle by fuel
consumption...lol.  And 20oz in 8min is too much.  More like 14oz in 8 min.

I'm sure Troy will have a super simple setting system...:)  But bottom line
I'm betting your just a few clicks rich.

-Mark


On 3/8/07 7:06 PM, "JShulman" <jshulman at cfl.rr.com> wrote:

> Hi all,
> 
> I've got my friends DZ and the high end needle is 1 1/8 turns out. The reg
> is somewhere around flush. It smokes and bunch, smooth transition, but 20ozs
> in less than 8 minutes if I'm not careful. I remember hearing (being told)
> that there is a less consuming set-up that I haven't done yet. Anyone know
> what it is? Gonna fly again tomorrow and try it. Thanks.
> 
> Regards,
> Jason
> www.jasonshulman.com
> www.shulmanaviation.com
> www.composite-arf.com
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.5.446 / Virus Database: 268.18.8/714 - Release Date: 3/8/2007
> 10:58 AM
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion