[NSRCA-discussion] Canopy/Hatch Latch

[Rex LESHER]

Jerry

I've used the little GR8066  latch...   I like it because it's small and doesn't require any brackets or formers for mounting.
Just lube the pin and bury it in your favorite epoxy concoction...   This is the same latch that comes with all of the Impacts.

Rex
  ----- Original Message ----- 
  From: Jerry Budd<mailto:jerry at buddengineering.com> 
  To: NSRCA Mailing List<mailto:nsrca-discussion at lists.nsrca.org> 
  Cc: dist7 at nsrca.org<mailto:dist7 at nsrca.org> 
  Sent: Monday, June 18, 2007 1:27 AM
  Subject: [NSRCA-discussion] Canopy/Hatch Latch


  Hi all,

  Does anybody have any experience with either of the middle two 
  latches shown here?

  http://tinyurl.com/yv6shv<http://tinyurl.com/yv6shv>

  I need a latch for the canopy on my latest project and I'm looking 
  for a good alternative to the BVM latch.

  Thx, Jerry
  -- 
  ___________
  Jerry Budd
  Budd Engineering
  (661) 722-5669 Voice/Fax
  (661) 435-0358 Cell Phone
  mailto:jerry at buddengineering.com<mailto:jerry at buddengineering.com>
  http://www.buddengineering.com<http://www.buddengineering.com/>
  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<http://lists.nsrca.org/mailman/listinfo/nsrca-discussion>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070618/f314961a/attachment-0001.html