[NSRCA-discussion] Futaba 14mz and compact flash card

Claude Weimer cweimer at tconl.com
Wed Jan 17 15:25:04 AKST 2007


I agree you can tell the difference with the 2048 resolution but it is not
enough better to go ahead and fly with the airplane going into hold. My
feeling was that cutting the antenna to 21.6" would probably fix it but then
I heard that it should not be cut. My question is why Futaba said not to cut
the antenna and then they started shipping the receivers with the shorter
antenna? 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ed Miller
Sent: Wednesday, January 17, 2007 6:10 AM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Futaba 14mz and compact flash card

I've used the R5014DPS receiver in 3 different planes now with no problems. 
I did not measure the length of the antennae wire prior to installation. 
Both my rx'es have the same length antennae, maybe later tonight I can 
remove 1 and measure it's length.  You will notice a difference, at least in

a well setup pattern plane going from 1024 to 2048 resolution.  I also 
noticed the 40% better update rate Futaba claims over the 9Z radios.  Other 
than the too soft factory stick springs and still too soft factory Futaba 
"stiff" springs for the 14mz, I'm very happy with it.  I ended up installing

stick springs from a 9Z radio to get the feel I was looking for.  I do not 
have the part number as I ordered them from Futaba some time ago but I do 
remember they were replacement springs for the 9Z.  I also purchased a 
genuine Sony NP-F570 battery and have used it for both programming and 
flying and can record no difference in charge times, Tx on times, etc.  The 
14mz is a battery hog in programming mode with the backlight on for the 
screen, mine will take the battery from 100% to 30% in about 50 minutes if 
solely programming.
Ed M.
----- Original Message ----- 
From: "Claude Weimer" <cweimer at tconl.com>
To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
Sent: Tuesday, January 16, 2007 9:07 PM
Subject: Re: [NSRCA-discussion] Futaba 14mz and compact flash card


> My question isn't about the card but about the antenna length on the R5014
> receiver. There was an article in RCU about cutting the antenna length to
> 21.6" to solve intermittent holds. Then I read something from Futaba that
> you should not cut the antenna, you should tighten any metal or carbon
> vibration to solve the problem. A friend bought a new radio with that
> receiver and it has the shortened antenna. So my question is if Futaba is
> shipping new receivers with the shorter antenna then why would they
> recommend not cutting the antenna? Holds no matter how short, unnerve me 
> to
> the point of not wanting to fly the airplane. I have been using 1024
> receivers with the 14mz radio.
>
> Claude Weimer
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ted Sander
> Sent: Tuesday, January 16, 2007 7:03 PM
> To: 'NSRCA Mailing List'
> Subject: Re: [NSRCA-discussion] Futaba 14mz and compact flash card
>
> Only as a bench test.  I had this 2 gig card for a camera, and popped it 
> in.
> It all seemed to work just fine.  Saved settings, recalled settings, much
> more room for tunes, etc.  Didn't test to see if there was a problem with 
> a
> large number of files on the card - possible the MZ itself can't display
> beyond a certain number.
> The system doesn't need the card except as storage space - so if the saved
> planes read in to the radio fine, I wouldn't expect any issues.  From the
> test, I will experiment once the temperature gets more reasonable for
> flying.  Minus 10 last night.....
>
> Ted Sander
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ed Miller
> Sent: Tuesday, January 09, 2007 7:11 AM
> To: NSRCA Mailing List
> Subject: [NSRCA-discussion] Futaba 14mz and compact flash card
>
> Has anyone tried a compact flash card in their 14mz other than the factory
> supplied 32MB compact flash card ??
> TIA.....Ed M.
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



More information about the NSRCA-discussion mailing list