[NSRCA-discussion] Sound proofing a glow engine cowling

[Lance Van Nostrand]

Lead and egg cartons.

----- Original Message ----- 
From: <adriancwong at earthlink.net>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, February 21, 2007 10:28 PM
Subject: Re: [NSRCA-discussion] Sound proofing a glow engine cowling


> Try foam. It will not only absorb some noise, if you install them 
> correctly, it can also re-direct and trap cold air around the cylinder 
> head section, it works on my 160 DZ.
>
> Adrian
>
> -----Original Message-----
>>From: Bob Richards <bob at toprudder.com>
>>Sent: Feb 21, 2007 8:02 PM
>>To: NSRCA Mailing List <nsrca-discussion at lists.nsrca.org>
>>Subject: Re: [NSRCA-discussion] Sound proofing a glow engine cowling
>>
>>Magnets, arranged in a circle, and spinning around an armature.
>>
>>  ;-)
>>
>>
>>"R. LIPRIE" <RLIPRIE at centurytel.net> wrote:
>>          Whats a good material to cut the noise to use inside the cowling 
>> of glow engines?
>>
>>  Matt. L  and Nat Penton
>>_______________________________________________
>>NSRCA-discussion mailing list
>>NSRCA-discussion at lists.nsrca.org
>>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion