[NSRCA-discussion] low profile JR servo?

Jay Marshall lightfoot at sc.rr.com
Wed Feb 21 04:29:00 AKST 2007


Linear output adapters are still available.

I remember a college class where we programmed analog and digital computers
then compared the results. Analog was always faster and more accurate.

 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob Richards
Sent: Wednesday, February 21, 2007 8:18 AM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] low profile JR servo?

 

Hah, I didn't even think about the stick pots. Seems that would be the first
place they would try using shaft encoders.

 

Linear outputs from the servos would be great, also. Oh, wait a minute, that
was done 35 years ago with the KPS-11 servos. Nevermind....   :-)

 

Bob R.

Earl Haury <ehaury at houston.rr.com> wrote:

Isn't technology great - $2000+ TX and $100+ servos with everything riding
on a 50 cent pot on each end! 

 

Earl

----- Original Message ----- 

From: Bob Richards <mailto:bob at toprudder.com>  

To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>  

Sent: Tuesday, February 20, 2007 8:37 PM

Subject: Re: [NSRCA-discussion] low profile JR servo?

 

When you say analog, I assume you are talking about the feedback loop? I
wonder how long it will be until we get shaft encoders in our servos. Or,
for that matter, the shaft encoder could be mounted to the control surface
itself.

 

Bob R.



"J.Oddino" <joddino at socal.rr.com> wrote:

Correct.  Well kind of.  Actually all of our servos are analog but you are
right, the super servos used the same principles as our modern "digital"
servos.

 

Jim O

----- Original Message ----- 

From: Bob Richards <mailto:bob at toprudder.com>  

To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>  

Sent: Tuesday, February 20, 2007 1:22 PM

Subject: Re: [NSRCA-discussion] low profile JR servo?

 

I was under the impression that the "Super Servos" were actually first
generation digital servos. Is that not correct?

 

Bob R.



 


  _____  


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070221/b0d6bdb7/attachment-0001.html 


More information about the NSRCA-discussion mailing list