[NSRCA-discussion] Metal Servo Arms

[k6xyz]

I had the same trouble with these arms.

It seems that the spline in the arm is the right size, but it has debris or
something in there.anyway, I was able to pick out some of the loose 'stuff'
in the spline and it went on easier but I think it is still too tight.

 

Regards

Dave Harmon
NSRCA 586
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok. 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of twtaylor
Sent: Thursday, August 30, 2007 7:50 AM
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] Metal Servo Arms

 

I bought some Hanger 9 alum servo arms and when I put them on they are VERY
hard to get to pull down on to the servo. Is this normal? They don't go down
as far as the plastic arms do. They are stamped with a J on the bottom so I
assume they're made for JR servo's.

 

Tim

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070830/4d3404b7/attachment.html