[NSRCA-discussion] 160Dz question

tocdon at netscape.net tocdon at netscape.net
Tue Aug 7 15:41:25 AKDT 2007


Take two, High speed needle out 1/4 , pump out 1/8
Call me in the morning.



-----Original Message-----
From: Ed Deaver <divesplat at yahoo.com>
To: NSRCA Mailing List <nsrca-discussion at lists.nsrca.org>
Sent: Sun, 5 Aug 2007 7:55 pm
Subject: [NSRCA-discussion] 160Dz question




Hey everyone.? Asking for a friend.? We are having problems getting his pump set properly.

?

Few specifics:

Cool Power 30% heli fuel, Tetra tank, new plumbing, YS foam clunk, APC 17X10 prop, 3500 ft altitude.

?

On up lines it would sag occasionally, but otherwise ran great (working on the Masters sequence)? Turned in (richened up) the pump a tad, better then one more time and the vertical sag stopped, but doing the outside 6sided loop in Advanced, with the bottom of the push, the engine spits and sputters terribly.? Strangely, not on any outside pushes in Masters, just this one manuever. 

?

Anythoughts???

?

Thanx in advance.

?

ed


Moody friends. Drama queens. Your life? Nope! - their life, your story.
Play Sims Stories at Yahoo! Games. 


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


________________________________________________________________________
Check Out the new free AIM(R) Mail -- Unlimited storage and industry-leading spam and email virus protection.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070807/f66dc554/attachment.html 


More information about the NSRCA-discussion mailing list