[NSRCA-discussion] 160Dz question

[Fred Huber]

May have needed to richen the top needle, but not increase pump pressure...

Sounds like you made the mid-range and maybe the low speed too rich.
  ----- Original Message ----- 
  From: Ed Deaver 
  To: NSRCA Mailing List 
  Sent: Sunday, August 05, 2007 6:55 PM
  Subject: [NSRCA-discussion] 160Dz question


  Hey everyone.  Asking for a friend.  We are having problems getting his pump set properly.

  Few specifics:
  Cool Power 30% heli fuel, Tetra tank, new plumbing, YS foam clunk, APC 17X10 prop, 3500 ft altitude.

  On up lines it would sag occasionally, but otherwise ran great (working on the Masters sequence)  Turned in (richened up) the pump a tad, better then one more time and the vertical sag stopped, but doing the outside 6sided loop in Advanced, with the bottom of the push, the engine spits and sputters terribly.  Strangely, not on any outside pushes in Masters, just this one manuever. 

  Anythoughts???

  Thanx in advance.

  ed


------------------------------------------------------------------------------
  Moody friends. Drama queens. Your life? Nope! - their life, your story.
  Play Sims Stories at Yahoo! Games. 


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition. 
  Version: 7.5.476 / Virus Database: 269.11.4/936 - Release Date: 8/4/2007 2:42 PM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070806/68700e77/attachment.html