[NSRCA-discussion] JR 9411 centering

[Wayne Galligan]

I guess a flat blade jewelers size screw driver would work...right?

  ----- Original Message ----- 
  From: k6xyz 
  To: 'NSRCA Mailing List' 
  Sent: Sunday, April 22, 2007 2:57 PM
  Subject: Re: [NSRCA-discussion] JR 9411 centering


  Hi Jim..



  That's correct.

  The way I do it is to set the tx subtrim and manual trim to zero, remove the servo output shaft screw, leave the servo arm on the servo and adjust the pot slightly until the arm is exactly 90 degrees to the side of the servo case.



  Regards

  Dave Harmon
  NSRCA 586
  K6XYZ[at]sbcglobal[dot]net
  Sperry, Ok. 

  -----Original Message-----
  From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of J.Oddino
  Sent: Sunday, April 22, 2007 2:20 PM
  To: NSRCA Mailing List
  Subject: [NSRCA-discussion] JR 9411 centering



  I seem to remember someone telling me one can adjust the neutral position of the 9411.  I assume it takes a small screwdriver down the center of the output shaft like the old Kraft servos.  Anyone know if this is true and how to do it?



  Jim O



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070422/997e8e6b/attachment.html