[NSRCA-discussion] JR 9411 centering

[k6xyz]

Hi Jim..

 

That's correct.

The way I do it is to set the tx subtrim and manual trim to zero, remove the
servo output shaft screw, leave the servo arm on the servo and adjust the
pot slightly until the arm is exactly 90 degrees to the side of the servo
case.

 

Regards

Dave Harmon
NSRCA 586
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok. 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of J.Oddino
Sent: Sunday, April 22, 2007 2:20 PM
To: NSRCA Mailing List
Subject: [NSRCA-discussion] JR 9411 centering

 

I seem to remember someone telling me one can adjust the neutral position of
the 9411.  I assume it takes a small screwdriver down the center of the
output shaft like the old Kraft servos.  Anyone know if this is true and how
to do it?

 

Jim O

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070422/9ebce589/attachment.html