[NSRCA-discussion] Brio Hinges

[Rusty]

Arch,

Go ahead and degrease the pipe before you monokote so that when the pipe 
falls off...

Rusty
----- Original Message ----- 
From: "Archie Stafford" <rcpattern at stx.rr.com>
To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
Sent: Monday, November 13, 2006 10:27 AM
Subject: Re: [NSRCA-discussion] Brio Hinges


> Looking back, It has worked so well on the hinges I think I might even 
> start
> Monokoting my pipe into the plane....
>
> A little NATS humor...
>
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Mark Atwood
> Sent: Monday, November 13, 2006 10:24 AM
> To: NSRCA Mailing List
> Subject: Re: [NSRCA-discussion] Brio Hinges
>
> Both of my use a combo of the thin Sig CA hinges...and Monokote.  Zero
> issues.  The thin paper CA hinges are extremely strong and work well for 
> the
> top hinging.  But I think you would have no problem JUST using Monokote. 
> I
> have always used Clear monokote to seal gaps anyway...this was just an
> extension of the color scheme.  Never had the monokote tear away or split.
>
> -M
>
>
> On 11/13/06 10:37 AM, "Richard Strickland" <richard.s at allied-callaway.com>
> wrote:
>
>>
>> What's the best way to hinge beveled surfaces as on the Brio kit?
>>
>> Richard
>>
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion