[NSRCA-discussion] Brio Hinges

[Pete Cosky]

Not a bad idea for you all things considered....

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Archie
Stafford
Sent: Monday, November 13, 2006 11:28 AM
To: 'NSRCA Mailing List'
Subject: Re: [NSRCA-discussion] Brio Hinges

Looking back, It has worked so well on the hinges I think I might even start
Monokoting my pipe into the plane....

A little NATS humor...


-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Mark Atwood
Sent: Monday, November 13, 2006 10:24 AM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Brio Hinges

Both of my use a combo of the thin Sig CA hinges...and Monokote.  Zero
issues.  The thin paper CA hinges are extremely strong and work well for the
top hinging.  But I think you would have no problem JUST using Monokote.  I
have always used Clear monokote to seal gaps anyway...this was just an
extension of the color scheme.  Never had the monokote tear away or split.

-M


On 11/13/06 10:37 AM, "Richard Strickland" <richard.s at allied-callaway.com>
wrote:

> 
> What's the best way to hinge beveled surfaces as on the Brio kit?
> 
> Richard
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion