[NSRCA-discussion] Brio Hinges

[vellum2 at bellsouth.net]

Hey Arch,
I'd switch to 1/2 lag screws for your pipe.  Better safe than sorry!

Joe W.
> 
> From: "Archie Stafford" <rcpattern at stx.rr.com>
> Date: 2006/11/13 Mon AM 11:27:38 EST
> To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
> Subject: Re: [NSRCA-discussion] Brio Hinges
> 
> Looking back, It has worked so well on the hinges I think I might even start
> Monokoting my pipe into the plane....
> 
> A little NATS humor...
> 
> 
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Mark Atwood
> Sent: Monday, November 13, 2006 10:24 AM
> To: NSRCA Mailing List
> Subject: Re: [NSRCA-discussion] Brio Hinges
> 
> Both of my use a combo of the thin Sig CA hinges...and Monokote.  Zero
> issues.  The thin paper CA hinges are extremely strong and work well for the
> top hinging.  But I think you would have no problem JUST using Monokote.  I
> have always used Clear monokote to seal gaps anyway...this was just an
> extension of the color scheme.  Never had the monokote tear away or split.
> 
> -M
> 
> 
> On 11/13/06 10:37 AM, "Richard Strickland" <richard.s at allied-callaway.com>
> wrote:
> 
> > 
> > What's the best way to hinge beveled surfaces as on the Brio kit?
> > 
> > Richard
> > 
> > _______________________________________________
> > NSRCA-discussion mailing list
> > NSRCA-discussion at lists.nsrca.org
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>