[NSRCA-discussion] OS140RX needle valve extension

[Bob Kane]

I don't extend the needle valve on my YS motors, I
turn down a 4-40 aluminum cap screw and put it in the
exiting hole in the needle valve. I have a small hole
in the side of the fuse alligned with the needle
valve. A balldriver will fit through the hole into the
cap screw. Clean, can't bump it. 

--- Scott Smith <js.smith at verizon.net> wrote:

> 
> I'm installing this engine in a Brio where a 2.5"
> needle valve extension
> (plus the required opening) is something I'd rather
> avoid.  Anybody have
> experience with cutting the needle valve body off
> the back plate and
> installing it to the airframe?  (engine is out of
> warranty)
> 
> Any other ideas?
> 
> Thanks,
> 
> Scott
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 


Bob Kane
getterflash at yahoo.com

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com