[NSRCA-discussion] electric interference question

[George Miller]

Thanks to all for the input/advice.  I'm running the HVBEC's successfully in my E-FocusII, IonX, and XeroG raptor conversion (all of which are running 10S lipo packs), but it is certainly worth a try.  I'll let you know what works!

George
  ----- Original Message ----- 
  From: Verne Koester 
  To: NSRCA Mailing List 
  Sent: Sunday, May 14, 2006 9:38 AM
  Subject: Re: [NSRCA-discussion] electric interference question


  George,
  I've heard numerous reports that BEC's are bad news for setups that use large battery packs (pattern-size versus foamy-size). I'd suggest running a separate battery for the Rx, leave the choke in between your ESC and Rx, and make sure your Rx is as far away from your ESC as possible. Hope this helps and let us know how you make out.

  Verne Koester
    ----- Original Message ----- 
    From: George Miller 
    To: NSRCA Mailing List 
    Sent: Saturday, May 13, 2006 10:48 PM
    Subject: [NSRCA-discussion] electric interference question


    OK, this isn't exactly a pattern plane, but this group has a lot of expertise so I thought I'd ask here:

    I have a Showtime which I've built as an electric with AXI 5320/28 and Jeti Advance Plus Opto 90 amp ESC with a HVBEC for RX power.  The radio is a JR 9303 TX and PCMS receiver.  

    The problem is that I am getting some RF interference.  Ground range check is OK to 100 feet with antenna down and motor off, but when motor is turned on, the rx locks out (PCM)  until I either walk back a few yards closer, or put up the antenna.  I have gone from ppm to pcm RX, put toroid "RF Filters" on the leads from the ESC and both elevator servo's ( plane designed with elevator servo's mounted in tail with long leads to RX). I have also braided the wires between the motor and the ESC.  My next step is to try a different ESC, but I thought I'd ask here before shelling out a couple of hundred bucks for a new ESC. 

    Any other thoughts?

    Thanks,

    George



----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060514/0cddf2b8/attachment-0001.html