[NSRCA-discussion] Elevator trim change

[Glenn Hatfield]

Yes.  Many of us have this issue; even with wood planes using carbon-fiber push rods. As you noted the expansion rates are different.

Randy

--- getterflash at yahoo.com wrote:

From: Bob Kane <getterflash at yahoo.com>
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] Elevator trim change
Date: Mon, 8 May 2006 08:04:04 -0700 (PDT)

My new Temptation is using a carbon pushrod system for
the elevator. The length is roughly 30" and it is all
carbon from the servo to the elevator horns except for
the titanium ends.

I have been experiencing significant (more on what I
consider significant later) trim changes in elevator
from one flight to another. I did some searching in
the RCU forums and found a two year old thread, the
conclusion (if there is such a thing in online forums)
is the expansion/contraction of the composite fuselage
is large relative to the change of a carbon pushrod
system if both are subjected to the same change in
temperature.

What I mean by significant is two or three clicks as
measured by my Stylus trim levers. My three previous
pattern planes all featured rear mounted elevator
servos with short (< 12") pushrod systems. These
planes exhibited little trim change (1 click) with
temperature swings.

I changed servos last night and will be test flying
this evening to see if the servo was contributing to
the trim change. 

What are other experiences with carbon
pushrod/composite fuselage combinations?

Bob Kane
getterflash at yahoo.com

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion