[NSRCA-discussion] BRIO 10

Jay Marshall lightfoot at sc.rr.com
Sun May 7 09:12:21 AKDT 2006


Chucked the pants. Finally had the weather and time to get in its first
flight. Using a recommended 480, 10x7 prop, Castle Phoenix controller, TP
2100 and servos in the tail. Plenty of power for this sportsman, and lots
more. No problem with axles - yet. Does a lot of things real well but a
knife edge isn't one of them. More than its share of roll coupling but I
really haven't started the trim flights yet.

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Joe Lachowski
Sent: Wednesday, May 03, 2006 2:22 PM
To: nsrca-discussion at lists.nsrca.org
Subject: Re: [NSRCA-discussion] BRIO 10

Chuck the wheel pants(0.6 ozs.), use NMP aluminum axles and the lightest 2 
inch  or so diameter wheels you can get your hands on.  I'm using the extra 
long fixed gear NMP axles with the Hobby Lobby LYT 2-1/16" wheels. Just 
happen to have had a couple of sets lof axles aying around. You'll even save

a couple tenths of an ounce in weight.


>From: "Jay Marshall" <lightfoot at sc.rr.com>
>Reply-To: NSRCA Mailing List <nsrca-discussion at lists.nsrca.org>
>To: "NSRCA" <NSRCA-discussion at lists.nsrca.org>
>Subject: [NSRCA-discussion] BRIO 10
>Date: Wed, 3 May 2006 12:59:39 -0400
>
>Anyone have a good solution to the weak axels?
>
>Jay Marshall
>


><< winmail.dat >>


>_______________________________________________
>NSRCA-discussion mailing list
>NSRCA-discussion at lists.nsrca.org
>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion





More information about the NSRCA-discussion mailing list