[NSRCA-discussion] OS 140RX rough and inconsistent idle
DaveL322 at comcast.net
DaveL322 at comcast.net
Mon Jun 26 09:47:33 AKDT 2006
Ed,
Long shot - but double check throttle servo mount/linkage, and mounting of engine, softmount, nosering, pipe, etc - any of that stuff gets loose, funny things can happen.
Anderson should have fuel for you.
Dave
-------------- Original message --------------
From: "Ed Miller" <edbon85 at charter.net>
> Have an OS 140RX that has developed a rough and inconsistent idle. Engine
> runs perfectly except for idle. It has a Mintor head with either an OS F or
> K&B 1L in center plug and an OS A5 in the angled plug position, a Perf Spec
> AAC piston/liner assembly and a Boca sealed SS rear bearing. I have the head
> mounted with angled plug towards the front or carb side of engine. Fuel is
> S&W 20 nitro, 16 synthetic and 2 castor. Engine has 7 gallons of fuel run
> through it. Prop is an APC 15.75 x 11 3 blade by Dave Lockhart. The lowest
> I can get the idle before it quits is 1900 ~ 2000 rpm and it is rough,
> sounds like it is firing every other revolution. Idle mixture screw is
> working, I can richen idle to point where engine will barely transition from
> being rich and I can lean mixture so the transition is fine but engine slows
> at idle like it is too rich. While it is slowing with either the idle
> mixture screw lean or rich, engine is rough, again like it often fires every
> other revolution at times. I used to be able to reliably idle this engine at
> 1300 rpm. I have a second OS 140RX set up exactly the same except it doesn't
> have the AAC piston/liner and it runs/idles perfectly. Tried cleaning the
> carb/spray bar with no change. I once had a Super Tiger that exhibited
> similar characteristics due to a worn out con rod. Is it possible the con
> rod on this OS could cause this issue ?? Any suggestions will be greatly
> appreciated.
> Ed M.
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060626/209c1e12/attachment.html
More information about the NSRCA-discussion
mailing list