[NSRCA-discussion] Brio Wing Dihedral?

[Anthony Romano]

Hi Lance,
How are you measuring this?

Anthony


>From: "Lance Van Nostrand" <patterndude at comcast.net>
>Reply-To: NSRCA Mailing List <nsrca-discussion at lists.nsrca.org>
>To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
>Subject: Re: [NSRCA-discussion] Brio Wing Dihedral?
>Date: Fri, 9 Jun 2006 07:33:32 -0500
>
>G,
>The Brio wing I am working with is from an unbult kit.  I'm questioning 
>this too, but the plane's a good flier so if this wing is not messed up 
>then it is what it is.  The 7/8" I measured is per panel.  I hope to get 
>confirmation.
>
>--Lance
>
>   ----- Original Message -----
>   From: george w. kennie
>   To: NSRCA Mailing List
>   Sent: Thursday, June 08, 2006 11:09 AM
>   Subject: Re: [NSRCA-discussion] Brio Wing Dihedral?
>
>
>   That sounds like a lot to me, Lance. Even if that's total (as opposed to 
>per panel), it sounds like a candidate for significant proverse roll 
>couple. The wing would need to be about 3&1/2" below the datum line for 
>that amount, and I certainly don't think that is the case.
>   G.
>
>
>
>     ----- Original Message -----
>     From: Lance Van Nostrand
>     To: NSRCA Mailing List
>     Sent: Wednesday, June 07, 2006 10:06 PM
>     Subject: [NSRCA-discussion] Brio Wing Dihedral?
>
>
>     I am measuring 7/8" dihedral on Brio wings.  Is this correct?
>
>
>----------------------------------------------------------------------------
>
>
>     _______________________________________________
>     NSRCA-discussion mailing list
>     NSRCA-discussion at lists.nsrca.org
>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
>------------------------------------------------------------------------------
>
>
>   _______________________________________________
>   NSRCA-discussion mailing list
>   NSRCA-discussion at lists.nsrca.org
>   http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


>_______________________________________________
>NSRCA-discussion mailing list
>NSRCA-discussion at lists.nsrca.org
>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion