[NSRCA-discussion] Break-in procedure for OS140

[Wayne Galligan]

Havent tried the 4 bladers yet as I have plenty of ground clearence.  I wished Tru-Turn made just the spinner caps for a reasonable price.  This prop experimenting can get expensive in more then one way.

Wayne G.
  ----- Original Message ----- 
  From: colin chariandy 
  To: NSRCA Mailing List 
  Sent: Tuesday, June 06, 2006 11:42 AM
  Subject: Re: [NSRCA-discussion] Break-in procedure for OS140


  I have the 19x10 but I don't think I have enough ground clearance. What's the consensous on the 15.5x12, 4 Blade? I would like to minimise left hand work while maximising speed control.

  Colin.

  Wayne Galligan <wgalligan at goodsonacura.com> wrote:

    2-3 Tanks on the ground then run slightly rich in the air for about 1 gallon. 
    On the ground for the first few tanks alterate from a rich needle stting to a good two cyle run for a few seconds then back to rich again.
    If you have access to a stainless bearing, replace it before running engine or you will be replacing the original in about 30-50 flights depending.

     Best if you can run on test stand and then you can adjust your pipe while breaking in. On 15% Cool Power and an Aeroslave c.f. pipe I am running the length at about 25-26 inches from center of plug to the main baffle.  My current engine is pulling a 19x10 Mejlik prop but the Lockhart 15.25x10 3-blade is a good choice and the new APC 18.1x10W 2-blade is good also.  Run the low end as rich as it will allow and you will get good downline braking with this setup.

    I wasnt so sure about using the Mejlik but after this weekend am convinced.  A few guys from the club commented that the downlines where as slow or the same speed as the upline.  So a big Yeh haa on the setup finally. Very quite too almost ELECTRIC LIKE.  It works good in moderate winds too.  I have yet to run it in winds over 15ish but I can always go to the trusty three blade.

    Wayne Galligan

      ----- Original Message ----- 
      From: colin chariandy 
      To: NSRCA Mailing List 
      Sent: Tuesday, June 06, 2006 7:55 AM
      Subject: [NSRCA-discussion] Break-in procedure for OS140


      Just got a new OS140. I have'nt broken in one for 5 years...what's the best/current practice for break-in?

      Colin.
      __________________________________________________
      Do You Yahoo!?
      Tired of spam? Yahoo! Mail has the best spam protection around 
      http://mail.yahoo.com 

--------------------------------------------------------------------------

      _______________________________________________
      NSRCA-discussion mailing list
      NSRCA-discussion at lists.nsrca.org
      http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


  __________________________________________________
  Do You Yahoo!?
  Tired of spam? Yahoo! Mail has the best spam protection around 
  http://mail.yahoo.com 



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060606/04f05aec/attachment.html