[NSRCA-discussion] Help: Elevator Setup on JR10X

[Dave Michael]

All,

I am setting up a new plane using the wing type mix (22) for an elevator 
servo on each half, plugging into the elevator and AUX3 ports as instructed.

Using the stick on each of the elevators coming together at a single point 
behind the rudder to check tracking.  I am finding that the elevators are 
aligned at center and at full up and down elevator.

I am also finding that the elevator on AUX 3 starts earlier and reaches full 
throw earlier than the other elevator and thus tracks with greater throw on 
that half than on the other half anywhere between neutral and full throw. 
This is happening with up elevator only- not down elevator.

I am hoping I can set up some sort of curve one one half or the other so 
that I can match the two elevators perfectly (well, as perfectly as 
possible).  Has anyone done this and what are the steps?

Thanks,

Dave Michael