[NSRCA-discussion] Back to pattern stuff

[Park, Ihncheol]

Adam,

Go with Futaba 3110, 22 oz torque, good price & light.  I sold bunch and got
them for my Kyosho Caliber 400,   I just dremel out the servo connector to
fit in the JR.  Now I have bunch of HS-55 that I have to get rid of.  I am
waiting on HS-65.

Ihncheol Park

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Adam Glatt
Sent: Wednesday, February 08, 2006 11:18 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Back to pattern stuff

Matt, on the subject of the JR DS281 mini digital servo, I have some
thoughts.  I bought two of them last summer for a 3Dfoamy.com superXtra
(1.14m span, layered depron flat shockie, outdoors, 17oz).  I used them in
rudder and elevator.  I found them to be extremely slow.  This was supposed
to be an aerobatic and slightly 3D plane, and I wished I had installed
faster servos.  The airplane flew like crap, so it wasn't a good test to
evaluate the 281, but I used them enough to figure out that they aren't the
best.

I'll probably be building a Stevens Aeromodels Edge540 this spring.  It will
weigh about 2 pounds, and from reading user reviews last fall, JR Sport
looked to have a servo or two that spec'ed attractively.  I've never done a
2-3lb electric, though, so I don't know which servo is best.

-Adam

Rcmaster199 at aol.com wrote:
> The landing gear will be simple carbon tubing with axles glued in. 
> Planning to use DS281's in the beastie on DaveL's recommendation with 
> the 770 rx
>  
> The final weight is projected at around 2 1/2 pounds where it should 
> be a fine match for the A30 M16 Hacker motor. A real pocket pattern 
> model
>  
> MattK
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion