[NSRCA-discussion] plane storage

[wgalligan]

JAS

Stretchmymount.....  Just hard mount it... no probs.

I do use the wing tube to hold it down when transporting it.   I made a
V-shaped cradle lined with 1" foam and set the plane in it and bungee it
down by the wing tube.  Then screwed the cradle to the floor.

WG


----- Original Message ----- 
From: "JShulman" <jshulman at cfl.rr.com>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Tuesday, December 19, 2006 1:47 PM
Subject: Re: [NSRCA-discussion] plane storage


> Why not hang it from the gear or wing tube socket then so you don't
> stretch
> your mount?
>
> Regards,
> Jason
> www.jasonshulman.com
> www.shulmanaviation.com
> www.composite-arf.com
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of wgalligan
> Sent: Tuesday, December 19, 2006 2:41 PM
> To: NSRCA Mailing List
> Subject: Re: [NSRCA-discussion] plane storage
>
>
> Hang it by the prop and you wont have any drain back from the pipe.  The
> prop/motor/mount is tougher then the tail feathers anyways.  Done this for
> years and have not had any problems
>
> Wayne Gallligan
>
>
> ----- Original Message -----
> From: "Richard Strickland" <richard.s at allied-callaway.com>
> To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
> Sent: Tuesday, December 19, 2006 10:50 AM
> Subject: Re: [NSRCA-discussion] plane storage
>
>
>> I've always stored them top side up--in a cradle--on a wall dedicated to
>> airplanes in the garage--(2) 18" brackets each.  Takes a lot of room--but
>> I
>> don't like to think of stuff draining back in to the engine in vertical
>> storage. The smaller stuff in a similar fashion on two 2 X 4" stanchions
>> in
>> a stand with adjustable wall hangers both sides and the 12" shelf
>> brackets
>> covered with pipe insulation foam products.  I suppose with the E stuff,
>> the
>> electrons won't gum up the motors as bad....but old dogs...
>>
>> RS
>>
>> -----Original Message-----
>> From: nsrca-discussion-bounces at lists.nsrca.org
>> [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Tim
>> Wortkoetter
>> Sent: Tuesday, December 19, 2006 10:18 AM
>> To: NSRCA Mailing List
>> Subject: [NSRCA-discussion] plane storage
>>
>>
>> Is it better to store the plane on its side or on the
>> bottom.  it horizontal stab vertical or horizontal.  I
>> don't know if it would effect the fuse and cause it to
>> warp or sag if it sits for an extended period of time.
>>
>>
>> Thanks,
>> Tim
>>
>> __________________________________________________
>> Do You Yahoo!?
>> Tired of spam?  Yahoo! Mail has the best spam protection around
>> http://mail.yahoo.com
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>
>>
>>
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>
>>
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.409 / Virus Database: 268.15.25/593 - Release Date:
> 12/19/2006
>
> --
> No virus found in this outgoing message.
> Checked by AVG Free Edition.
> Version: 7.1.409 / Virus Database: 268.15.25/593 - Release Date:
> 12/19/2006
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>