[NSRCA-discussion] YS 160 help needed

[Steve Ford]

Hi Robert.   The check valve assembly didn't come apart, it was the bottom of it that goes down into the motor that came out.  I may not be describing it correctly, i'm a little mechanically challenged. :))

Thanks,
Steve
  ----- Original Message ----- 
  From: Robert & Casey Green 
  To: NSRCA Mailing List 
  Sent: Wednesday, August 09, 2006 8:25 PM
  Subject: Re: [NSRCA-discussion] YS 160 help needed


  Steve see if you can use a fuel tubing to connect the two together
    ----- Original Message ----- 
    From: Steve Ford 
    To: NSRCS Board 
    Sent: Wednesday, August 09, 2006 8:20 PM
    Subject: [NSRCA-discussion] YS 160 help needed


    Hi all.  Tonight on my YS 1.60 the check valve came out of the head of the motor.  It appears to be just a pressure fitting, pushed it back in, but wouldn't stay in.

    Any help would be greatly appreciated, contest this weekend of course.  My thoughts are leaning towards jb weld or something similar.  

    Thanks,
    Steve Ford


----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition.
  Version: 7.1.394 / Virus Database: 268.10.8/415 - Release Date: 8/9/2006
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060810/7c4080b0/attachment.html