[NSRCA-discussion] Carbon fiber tube push rods

[jivey61 at bellsouth.net]

And if the end trys to splinter a drop of CA will fix it.

Jim Ivey
  ----- Original Message ----- 
  From: jivey61 at bellsouth.net 
  To: NSRCA Mailing List 
  Sent: Sunday, April 23, 2006 9:23 PM
  Subject: Re: [NSRCA-discussion] Carbon fiber tube push rods


  Jim
   I use a dremel cutoff wheel. Roll the tube while cutting.Don't breath the dust of course.
  Jim Ivey
    ----- Original Message ----- 
    From: Jim Oliver 
    To: NSRCA-discussion at lists.nsrca.org 
    Sent: Sunday, April 23, 2006 9:03 PM
    Subject: [NSRCA-discussion] Carbon fiber tube push rods


    Hey guys,

    What is the best way to cut the carbon fiber push rods (hollow tube)?

    Thanks,
    Jim Oliver


----------------------------------------------------------------------------
    Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2¢/min with Yahoo! Messenger with Voice. 


----------------------------------------------------------------------------


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060424/40fdc0fe/attachment.html