[NSRCA-discussion] Carbon fiber tube push rods

[jivey61 at bellsouth.net]

Jim
 I use a dremel cutoff wheel. Roll the tube while cutting.Don't breath the dust of course.
Jim Ivey
  ----- Original Message ----- 
  From: Jim Oliver 
  To: NSRCA-discussion at lists.nsrca.org 
  Sent: Sunday, April 23, 2006 9:03 PM
  Subject: [NSRCA-discussion] Carbon fiber tube push rods


  Hey guys,

  What is the best way to cut the carbon fiber push rods (hollow tube)?

  Thanks,
  Jim Oliver


------------------------------------------------------------------------------
  Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2¢/min with Yahoo! Messenger with Voice.


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060424/d1644502/attachment.html