[NSRCA-discussion] Perry pump/carb

[Wayne Galligan]

One more thing Larry.... make sure to get the 5000 series large bore carb 
when using the pump.   I think the carb listed on the Tower site is for the 
standard fuel draw system.

email me off line if you have any question wgalligan at texasairnet.com

Good luck,

Wayne
----- Original Message ----- 
From: "Wayne Galligan" <wgalligan at goodsonacura.com>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, April 19, 2006 5:55 PM
Subject: Re: [NSRCA-discussion] Perry pump/carb


> Larry,
>
> http://www.perrypumps.com/
>
> Here you go.  I have this setup on my ST2300 and it works great.  Once I
> have it set I RARELY have to touch the needle.   On a pipe and 15% nitro 
> the
> engine will turn a 17x10N APC the best at about 8400rpm.  I have mine
> currently in a Funtana on a canister muffler and it swings an 18x6 wood 
> prop
> just fine.   I have over 450 flights on the motor and have yet to change a
> bearing.
>
> Wayne Galligan
>
> http://www.perrypumps.com/
>
>
> ----- Original Message ----- 
> From: "Larry Krutz" <lkrutz89503 at yahoo.com>
> To: <nsrca-discussion at lists.nsrca.org>
> Sent: Wednesday, April 19, 2006 1:05 PM
> Subject: [NSRCA-discussion] Perry pump/carb
>
>
>>I need a good source for the pump/carb for the ST2300.
>> TIA --Larry
>>
>>
>> __________________________________________________
>> Do You Yahoo!?
>> Tired of spam?  Yahoo! Mail has the best spam protection around
>> http://mail.yahoo.com
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion