YS 1.20 AC

[Richard Strickland]

Hi Jerry,

You might check to see if your motor mount or something else has loosened a bit and allows some part to come in contact with something it shouldn't--like pinching a line. Possibly look at the nose ring area and a shift that may cause some drag.  Don't you love the intermittent mystery?!

Richard
  ----- Original Message ----- 
  From: jjvoth 
  To: discussion at nsrca.org 
  Sent: Friday, May 20, 2005 1:17 PM
  Subject: YS 1.20 AC


  Anyone have any ideas why this engine quits running  when exiting the triangle loop or the full roll after the half inside loop in the Masters pattern.
  I can't remember ever having this engine quit since it was new. I've checked the fuel lines, replaced the pickup line in the tank, changed the diaphragm, checked the fuel passages in the regulator and carb, changed plugs, reset the idle screw and cleaned the filter. It runs fine with plenty of power (for an AC) and it doesn't quit on the above maneuvers every time.

  Any help would be appreciated.

  Jerry
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050520/56a79868/attachment.html