AeroFly sim transmitter?

[Jerry Budd]

The frequency module IS the RF module, they're the same thing.  If 
you unplug it there is no load on the transmitter other than the 
encoder.  Also, on most transmitters, plugging in the DSC cord 
bypasses the RF output (same as unplugging the RF module).

Jerry


>That's a good idea.  But I don't have a 7UAP.  I've got an 8U, but I 
>think the freq module is all that can be removed.  Don't know how to 
>remove the RF.  I've also got a boxful of Conquests, 6XA's and other 
>low end transmitters.  Are there any RF lobotomizing instructions 
>out there for other radios that don't make it so convenient?
>--Lance
>
>
>----- Original Message -----
>From: <mailto:AtwoodDon at aol.com>AtwoodDon at aol.com
>To: <mailto:discussion at nsrca.org>discussion at nsrca.org
>Sent: Wednesday, May 11, 2005 7:38 PM
>Subject: Re: AeroFly sim transmitter?
>
>Lance, I just got Aerofly Pro myself and have been using an older 
>Futabe 7UAP with no RF module in it for the TX.  Battery lasts 
>forever without an RF load on it.  Works great and I am not wearing 
>out my 'good' TX.  I am impressed by the 'feel' of Aerofly Pro 
>compared to the older Realflight G2.  Have also tried the Realflight 
>G3 and my vote goes for AFP.  The included Smaradg feels real good, 
>actually snaps and spins and the out of the box setup is pretty 
>close.  I increased the down elev throw a little and also bumped the 
>rudder a little and that is all.
>
>Don
>
>In a message dated 5/11/2005 5:31:27 P.M. Pacific Daylight Time, 
>patterndude at comcast.net writes:
>
>So I think I've seen that most everyone thinks the Ikarus AeroFly 
>Pro simulator is good for pattern.  I'm thinking of getting a sim 
>but I'm nervous about using my transmitter with the antenna down. 
>Don't want to overload the RF and I don't want to sit at my computer 
>with a 3 foot antenna banging off my office furniture.  Oh, and I 
>don't want to buy a new transmitter that lets me turn off the RF. 
>What are you all doing for a transmitter?
>--Lance
>
>


-- 
___________
Jerry Budd
Budd Engineering
(661) 722-5669 Voice/Fax
(661) 435-0358 Cell Phone
mailto:jerry at buddengineering.com
http://www.buddengineering.com
=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.