TRUTURN FAI 3-1/2' SPINNER

[Grow Pattern]

As you know they will cut out to order for any size or 3/4 blade. The 
question was asked so that he could pre-cut a batch of spinners to satisfy 
orders quicker and be ready for Toledo.

I'll fwd the data to him as it comes in.

Jerry,
           I thought about the electrics. I have that prop. Can you confirm 
that the typical electric guy would use a TT spinner. I was thinking that 
they might go for a lightweight alternative because there is no need to 
support a starter motor?

Regards,

Eric.


----- Original Message ----- 
From: "Jerry Budd" <jerry at buddengineering.com>
To: <discussion at nsrca.org>
Sent: Friday, March 25, 2005 9:47 PM
Subject: Re: TRUTURN FAI 3-1/2' SPINNER


> >Any other props???
>
> e22x12
> -- 
> ___________
> Jerry Budd
> Budd Engineering
> (661) 722-5669 Voice/Fax
> (661) 435-0358 Cell Phone
> mailto:jerry at buddengineering.com
> http://www.buddengineering.com
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.