How much straight is straight enough

[Jerry Budd]

Don't you mean flat?  Whether it's level or not is only relevant if 
you're taking height or angular measurements from the table surface 
referenced with gravity based measurements from a level or plum bob.

Jerry

>Try shimming the areas that are sagging. My bet is that you can get it
>closer to level.
>
>I would not be happy with that much sag, but then again I'm pretty anal.
>
>Keith

-- 
___________
Jerry Budd
Budd Engineering
(661) 722-5669 Voice/Fax
(661) 435-0358 Cell Phone
mailto:jerry at buddengineering.com
http://www.buddengineering.com
=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.