Temperatures acceptable for equipment while flying.....?

Thu Jan 6 11:25:52 AKST 2005

Yes it could, if I remember my First Aid correctly, I like your "disclaimer", though I can't imagine it necessary<BG>

Ken
  ----- Original Message ----- 
  From: Del Rykert 
  To: discussion at nsrca.org 
  Sent: Thursday, January 06, 2005 10:16 AM
  Subject: Re: Temperatures acceptable for equipment while flying.....?

  Very true Ken..  But the nurses side of me likes to keep all safe from hurting themselves. Seen to much of it in warmer temps. Course you can pack the wound with clean snow and ice to stop the bleeding..  That is mentioned jokingly in case someone wants to take it to seriously. It would work in right circumstances done correctly though.

      Del

    ----- Original Message ----- 
    From: Ken Thompson III 
    To: discussion at nsrca.org 
    Sent: Thursday, January 06, 2005 7:46 AM
    Subject: Re: Temperatures acceptable for equipment while flying.....?

    Yes Del, 
    But just think of the extra protection you have with those heavy gloves, when you reach through the prop to richen your needle.:-)

    Sorry, that's as good as the jokes get this time of the morning.

    Ken

      ----- Original Message ----- 
      From: Del Rykert 
      To: discussion at nsrca.org 
      Sent: Thursday, January 06, 2005 7:20 AM
      Subject: Re: Temperatures acceptable for equipment while flying.....?

      I call it smart. Much easier to get caught up in whirling meat cleaver with heavy bulky clothing and keepings ones balance, let alone not having good feeling in extremities to maintain safety. Everyone is different and has different tolerances to heat and cold. Ask those that have fainted? Is much easier to happen next time after heat stroke. As I stated...  I will stick with calling it smart. 

          Del

        ----- Original Message ----- 
        From: Jeff Hughes 
        To: discussion at nsrca.org 
        Sent: Wednesday, January 05, 2005 7:53 PM
        Subject: Re: Temperatures acceptable for equipment while flying.....?

        Man, I'm disappointed, I thought all pattern fliers were tough, disciplined and skilled. I guess two out of three ain't bad! 
          ----- Original Message ----- 
          From: Ron Van Putte 
          To: discussion at nsrca.org 
          Sent: Wednesday, January 05, 2005 5:54 PM
          Subject: Re: Temperatures acceptable for equipment while flying.....?

          On Jan 5, 2005, at 3:52 PM, Jeff Hughes wrote:

            So how do you guys ice fish down there?

          I was born in Rochester, NY and have seen all the ice I care to see, unless it's with some single malt Scotch.

          Ron Van Putte

            ----- Original Message -----
            From: Earl Haury 
            To: discussion at nsrca.org 
            Sent: Wednesday, January 05, 2005 10:18 AM
            Subject: Re: Temperatures acceptable for equipment while flying.....?

            Chris

            I pretty much agree with Karl, Chad, & Eric. The balsa foam airplane may change trim, depending on the linkage, hard to tell just what will happen with the composites. Batteries are the biggest concern. When I lived where it got cold I would test airborne radio systems in the freezer at 0F. About 25% of the servos simply quit working - everything else seemed OK. As the most volatile fuel component has a flash point (makes flammable vapors) of +50F, engine starting is a problem. As Karl mentions, lighter fluid (couple of drops) helps. My record for cold flight is -6F, but the best solution I've found is moving south - been in the upper 70's in Houston all week.

            Earl
            ----- Original Message -----
            From: Karl G. Mueller 
            To: discussion at nsrca.org 
            Sent: Wednesday, January 05, 2005 8:53 AM
            Subject: Re: Temperatures acceptable for equipment while flying.....?

            Chris,

            Extreme cold and ultra violet rays will make most plastics more brittle.
            You will not get as much power out of your batteries as would in warmer
            weather.
            In the years when we were running the .60 size engines we would use
            Lighter Fluid to get the engines started.
            Now I just don't go out any more in the cold weather. It does not get as cold
            around here (Toronto.Ontario) as it does out west. They were having -35 Cº
            with a wind chill  to - 45 Cº.  Brrrrrrrrrrrrrrr.
            You wont stay outside longer than you have too at these temps.

            Karl G. Mueller
            kgamueller at rogers.com

            ----- Original Message -----
            From: White, Chris 
            To: discussion at nsrca.org 
            Sent: Wednesday, January 05, 2005 8:05 AM
            Subject: Temperatures acceptable for equipment while flying.....?

            Hi,

            Hey, I was out flying on Christmas Eve in OK and it was about 22 degrees.....  I spent extra time warming the YS at idle, but thoughts were crossing my mind about how bad the cold weather is on our equipment (nylon components etc....) .  I'm sure the guys up North have limits on cold temps and I'd be interested to hear your concerns or special cares.

            I'm running a balsa/foam airplane, YS140 Sport (30% CP Heli fuel), and a JR PCM 10X with Digitals and Nimh batteries.

            Thanks for your feedback....!
            Chris White 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050106/dbd66f3a/attachment-0001.html