Question on Bearing change out

[John Pavlick]

Wayne,
 I'm trying the same thing with some Boca bearings this season in an OS 160.
I bought S.S. front and rear bearings with seals (both sides). I left the
seals on thinking that the bearings will just run in the "lifetime
lubricant" (grease) that the bearings have from the factory. I'm hoping that
keeping the fuel out of the bearings might be a good thing. The only thing
I'm concerned about is the amount of drag from the grease. Fuel / oil is
much thinner so it offers less resistance at high RPM. If the motor doesn't
rev up as expected I'll just pull the seals off of the rear bearing, I
guess.

John Pavlick
http://www.idseng.com


> -----Original Message-----
> From: discussion-request at nsrca.org
> [mailto:discussion-request at nsrca.org]On Behalf Of Wayne Galligan
> Sent: Monday, February 21, 2005 2:37 PM
> To: discussion at nsrca.org
> Subject: Re: Question on Bearing change out
>
>
> I use the Purvis bearings and leave the rubber seals in them and have had
> good service with that setup.  OS 1.40  has over 130 flights and still
> running strong.
>
> Wayne G.


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.516 / Virus Database: 313 - Release Date: 9/1/03

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.