Polyurethane Glue Solvent

[Bob Pastorello]

Ron, you may want to have some water and extra Monokote handy.... <VBG>

Bob Pastorello
NSRCA 199  AMA 46373
rcaerobob at cox.net
www.rcaerobats.net


  ----- Original Message ----- 
  From: Ron Van Putte 
  To: discussion at nsrca.org 
  Sent: Saturday, February 19, 2005 7:32 PM
  Subject: Re: Polyurethane Glue Solvent



  On Feb 19, 2005, at 7:22 PM, Bob Pastorello wrote:


    Yeah, Bob, a soft-flame torch would remove the glue.


  By golly! I think he's on to something. I'll try that tonight.

  Ron Van Putte


    ----- Original Message -----
    From: Bob Richards 
    To: discussion at nsrca.org 
    Sent: Saturday, February 19, 2005 7:21 PM
    Subject: RE: Polyurethane Glue Solvent

    I wonder if a heat gun might soften it enough to peel it off.

    spbyrum <spbyrum at hiwaay.net> wrote:
    The instructions say acetone to clean up while it's wet and 80 Grit
    after drying. Bummer on the monocote.

    Steve Byrum

    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
    On Behalf Of Ron Van Putte
    Sent: Saturday, February 19, 2005 1:08 PM
    To: discussion at nsrca.org
    Subject: Polyurethane Glue Solvent

    Does anyone know of a good solvent (gets the job done, but doesn't
    dissolve the surface it's on) for dried polyurethane glue? I
    accidentally spilled Gorilla Glue on a MonoKoted wing and didn't
    discover it until the glue had dried. I've tried several solvents
    without success. Help!

    Ron Van Putte

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050220/627886dc/attachment.html