Composite-ARF Impact question

[Weimer, Claude]

Did you only cut the fin on the flat that will be under the counterbalance or did you go farther forward? I have been trying to figure out how to fix this since I received the plane.

Claude

-----Original Message-----
From: Hotrod34a at aol.com [mailto:Hotrod34a at aol.com]
Sent: Tuesday, February 01, 2005 1:03 PM
To: discussion at nsrca.org
Subject: Re: Composite-ARF Impact question

Jim,
  I have two Impacts and both had a vertical fin that was not straight.  I split the top of the fin and then when I set the tailpost I applied clamps to hold it straight while the epoxy set.  Result is a very straight vertical fin and rudder.  Larry....
=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.