Composite-ARF Impact question

[J.Oddino]

Thanks Larry, makes sense.  I was hoping not to cut it but it makes sense.
Jim
----- Original Message ----- 
From: <Hotrod34a at aol.com>
To: <discussion at nsrca.org>
Sent: Tuesday, February 01, 2005 11:03 AM
Subject: Re: Composite-ARF Impact question


> Jim,
>   I have two Impacts and both had a vertical fin that was not straight.  I
split the top of the fin and then when I set the tailpost I applied clamps
to hold it straight while the epoxy set.  Result is a very straight vertical
fin and rudder.  Larry....
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.