Interesting incidence question

[iintheskyguy]

Anthony ,
Your meter is reading correct and there is NO misalignment between the stab halfs! If you take your meter and have it facing out (the pointer) when its mounted on the stab then one side will read postive and one side will read negitive. As long as the NUMBERS match then the stab is alignment. What you need to check is the level built into the meter. Postive would have the bubble towards the front of the plane and negitve towards the rear of the plane. Most likely your datum line is off (center line through the fuse) I would mount the meter on the stab and level the fuse so the stab reads zero. Then verify that the fuse is level. By the way it helps to have two guages. One on the stab and one on the wing. 

Scott
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040919/5ff8a295/attachment.html